NEWS CENTER
Detection method of Pudong automation fully automatic wire terminal machine!
2020-02-12
1. Peeling openings vary in length:
There are many reasons for the difference in openings. The most common is that the wire feeding roller is pressed too tightly or loosely. At this time, you only need to use the roller fine adjustment to adjust the gap between the two wheels so that the wire is not flattened and slips too loosely. If it is because the cutting blade is too shallow or too deep; then we use the cutting depth adjustment to adjust the blade to the appropriate position, which does not hurt the copper wire and can smoothly peel off the rubber. If the openings are still different, replace the new cutting blade directly.
2. Uneven copper wire exposed on the crimp terminal:
Check whether the gun-type swing arm catheter is attached to the wire; whether the terminal of the terminal machine is relatively straight with the swing arm catheter; whether the auxiliary clamp of the terminal machine is loose; check whether the distance between the terminal machine and the automatic machine has changed.
3. The automatic wiring terminal machine cannot start or stop during operation:
Unable to start or stop during operation, you must first check whether there is current input and 6KG air pressure, and there is a wireless material or a certain operating part is stuck; also check whether the terminal machine is connected to the terminal without signal or power connection. .
4. The electronic wire cutting length of the automatic cable terminal machine is not consistent:
It may be that the cutting edge is worn or the cutting edge; the problem is very simple is to replace it with a new one. It may also be because the wire feeding roller is pressed too tightly or too loosely; at this time we can use the roller fine adjustment to adjust the gap between the two wheels so that the wire does not flatten and slips too loosely.
Fully automatic wire terminal machine Fully automatic wire terminal machine can be found in Changzhou Pudong Automation Equipment Co., Ltd., a professional full automatic wire terminal machine manufacturer
Contact Information
Business Consulting:
+86-18861100037 Grace
+86-18861130806 luisa
Address: Building 36, No. 158 Jinchuang Road, Changzhou Economic Development Zone, Jiangsu Province
Esperanto
Shqiptare
Euskara
Zulu
Latinus
Cymraeg
தமிழ்
Slovak
Slovak
Afrikaans



